Discussion for gate 2016 chemical engineering and further process for recruitment of PSU's.
Can anyone tell, the best way to cover-up whole syllabus in 3 months...???
Ans??
At constant dbt , if relative humidity decreses than what abt wbt?
any feedback about the gate 2016 question paper..?
anyone here to discuss the questions?
Anyone has link for key
Expected marks gate 2016 chemical
- 30-35
- 35-40
- 40-45
- 10-20
- 50-65
- 65+
- 45-50
- less than 10
- 20-25
- 25-30
0 voters
What is expected score for top 100 ranks?
- 60-65
- 65-70
- 70+
- 55-60
- <55
0 voters
Expected rank around marks 45 chemical gate 16???
RESPONSE SHEET IS RELEASED
Bhaiyo response sheet Aa gyi
In an experimental setup, mineral oil is filled in between the narrow gap of two horizontal smooth plates. The setup has arrangements to maintain the plates at desired uniform temperatures. At these temperatures, ONLY the radiative heat flux is negligible. The thermal conductivity of the oil does not vary perceptibly in this temperature range. Consider four experiments at steady state under different experimental conditions, as shown in the figure below. The figure shows plate temperatures and the heat fluxes in the vertical direction
What is the steady state heat flux (in W m‒2 ) with the top plate at 70o C and the bottom plate at 40o C? (A) 26 (B) 39 (C) 42 (D) 63
What is the natural period of oscillation (in seconds) of the system?
This question is wrong and we should ask gate iisc for bonus....it should be in minutes instead of second.
Q.49 A porous pellet with Pt dispersed in it is used to carry out a catalytic reaction. Following two
scenarios are possible.
Scenario 1: Pt present throughout the pores of the pellet is used for catalyzing the reaction.
Scenario 2: Pt present only in the immediate vicinity of the external surface of the pellet is used for
catalyzing the reaction.
At a large value of Thiele modulus, which one of the following statements is TRUE?
(A) Since the reaction rate is much greater than the diffusion rate, Scenario 1 occurs
(B) Since the reaction rate is much greater than the diffusion rate , Scenario 2 occurs
(C) Since the reaction rate is much lower than the diffusion rate, Scenario 1 occurs
(D) Since the reaction rate is much lower than the diffusion rate, Scenario 2 occurs
Terms used in engineering economics have standard definitions and interpretations. Which one of the following statements is INCORRECT?
(A) The profitability measure 'return on investment' does not consider the time value of money
(B) A cost index is an index value for a given time showing the cost at that time relative to a certain base time
(C) The 'six-tenths factor rule' is used to estimate the cost of an equipment from the cost of a similar equipment with a different capacity
(D) Payback period is calculated based on the payback time for the sum of the fixed and the working capital investment
An ideal gas is adiabatically and irreversibly compressed from 3 bar and 300 K to 6 bar in a closed system. The work required for the irreversible compression is 1.5 times the work that is required for reversible compression from the same initial temperature and pressure to the same final pressure. The molar heat capacity of the gas at constant volume is 30 J mol‒1 K‒1 (assumed to be independent of temperature); universal gas constant, R is 8.314 J mol‒1 K‒1; ratio of molar heat capacities is 1.277. The temperature (in K, rounded off to the first decimal place) of the gas at the final state in the irreversible compression case is _______
Guys, How many marks are you getting?
Gate 16 chemical paper easier/difficult/similar to that of gate 15 paper..everybody comment..