A solid bar 200mm L, 50 w, 50h . apply 20KN force, E 200GPa
fusible plug kya hoga
there was a ques......in vapour compression cycle, on superheating the cop is decreasing because statement 1- work of compression increases statement 2- it does not depend upon refregeration effect.
Chip thickness in milling depends upon feed
one ques was on fire tube boiler and watertube boiler with three statements......not exactly remembering the statements
multi-stage compressor wala b tha
what was the statement about flash in drop forging excatly not remember
lift ka kya answer hoga 12 or 8
the seeming contradiction that the weight of the fluid poured into a vessel can be different from the force of the pressureexerted by it on the bottom of the vessel. Thus, in a vessel that is wider at the top, the force of the pressure on the bottom isless than the weight of the fluid, whereas in one that is wider at the bottom, it is greater. In a cylindrical vessel both forces arethe same. If the same fluid is poured up to the same height in vessels of different shapes but the same bottom areas, thendespite the differences in the weight of fluid poured into the vessels, the force of the pressure on the bottoms is identical forall the vessels and is equal to the weight of the fluid in the cylindrical vessel. This follows from the fact that the pressure of aquiescent fluid depends only on the depth under a free surface and the density of the fluid.The hydrostatic paradox is explained by the fact that, since the hydrostatic pressure is always normal to a vessel’s walls, theforce of the pressure on the inclined walls has a vertical component that compensates for the excess weight of the volume offluid in a vessel that is wider at the top than a cylindrical vessel with the same bottom area and compensates for the lack ofweight of the volume of fluid in a vessel that is narrower at the top. The paradox was discovered by the French physicist B.Pascal.
fluid se ek question tha statement ii bernouli applied invissid flow uska kya hoga
knocking and pre-ignition ka kya hoga
Ek fluid ka question tha deformation ko leke...
82
bhailog ek option tha jisme tha question answer and review uske marks add nhi hnge na ...plz confirm it...
How much might be the Cutoff
I think cutoff will be arround
160 -170 for general
ek EDM m/c ka bhi tha.
ZERO dimension defect wala b tha ek
which property decrease plastic deformation of tool while machining
Streamline and Pathlines are instantaneous (Statement Right or Wrong)