most confused question ...answer ?
Production flow analysis is a method of identifying part families that ues data from
A engineering drawings
B production schedule
C Bill of Materials
D Route sheets
in rolling process stress 1.pure compression 2.shear and compression
a cylindrical vessel with flat bottom deep drawn by 1.double 2.triple action drawing
Anyone knows about these things about JWM 2014 EXAMINATION please tell. I search on google but not able to find 1.. cuttoff (for interview and final selection). 2... written and interview marks ratio(75:25 or 50:50) 3... paper level (difficult or same or easy ,as compared to ESE level.)
The best choice of antifriction bearing to support a shaft carrying a single helical gear is
- Thrust bearing
- Self aligning ball bearing
- Deep groove ball bearing
- Tapered roller bearing
0 voters
Consider the following statements : 1. Both Otto and Diesel cycles are special cases of dual combustion cycle 2. Combustion process in IC engines is neither fully constant volume nor fully constant pressure process 3. Combustion process in ideal cycle is replaced by heat addition from internal source in closed cycle 4. Exhaust process is replaced by heat rejection in ideal cycle Which of the above statements are correct? (a) 1, 2 and 3 (b) 3 and 4 only (c) 1, 2 and 4 only (d) 1, 2, 3 and 4
Which has maximum reduction in cross section area??
Rolling
Extrusion
Forging
Drawing
Which of the following shows strain hardening effect??
Rolling
Extrusion
Forging
Drawing
Deep drawing
Also write type of stresses associated with all these processes.
How many students are appearing for this exam any idea and how many students are called for interview
Last moment important chapters for material science subject? ?
JUNIOR WORKS MANAGER EXAM (JWM) 2014 MECHANICAL PAPER QUESTIONS AND ANALYSIS part 3
https://www.youtube.com/watch?v=IgBO3P63y6c
What are the types of questions asked in isro interview ... is there anyone preparing for it ...or if anyone had previously attended the interview ..plz share your experience and help me
Only asking techanical question ...????
Calculator allowed hain kya
What are the documents required to be carried on day of exam with admit card and ID.
kindly share ur next highest roll no.-
it will give idea of no. of candidates
mine 14658
Are mechanical properties of rolled product higher than extruded product??
Are surface finish of rolled product higher than extruded product
Q.no.67.. ans in book is (b)... right or wrong